Automatic - The temperature is set according to the energy-saving
schedule. To place the thermostat in this mode, press Mode until is dis-
The thermostat’s screen is blank.
The thermostat’s switch is on Standby.
The measured temperature is below 0°C
played. The icons of the current period and preset temperature are also dis-
LO is displayed.
32°F). Heating is activated.
The measured temperature is above 50°C
Temporary Bypass: If you modify the setpoint (by pressing the
or button) when the thermostat is in automatic mode, the new set-
point will be used until the end of the current period. When the next
period starts, the temperature set for that period becomes the new set-
HI is displayed.
The thermostat was without power for
more than 2 hours.
The wrong time is displayed.
The thermostat is located in a spot
exposed to an air draft.
The measured temperature is wrong.
The heater is always On.
Manual - The energy-saving schedule is not used. The temperature must
be set manually. To place the thermostat in this mode:
The thermostat indicates that heating is On
but the heater is not On.
Press Mode until
Set the temperature using the
Vacation - The thermostat is set to the Vacation temperature. Press
Check that the thermostat is in Automatic
mode. Check also the energy-saving
schedule and clock settings.
The temperature does not change accord-
ing to the energy-saving schedule
buttons simultaneously to place the thermostat in Vacation
Power: 240 Vac, 50/60 Hz
Load: 16.7 A maximum (resistive only)
Power: 4000 watts (NI) @ 240 Vac
Display range: 0°C to 60°C (32°F to 140°F)
Display resolution: 0.1°C (0.1°F)
Setpoint range: 5°C to 30°C (40°F to 86°F)
Setpoint interval: 1°C (1°F)
The schedule consists of 4 periods per day which represents a typical week
day. You can program the thermostat to skip the periods that do not apply to
your situation. For example, you can skip periods 2 and 3 for the weekend.
Associated preset temperature
Storage: -20°C to 50°C (-4°F to 120°F)
Data backup: In the event of a power failure, most settings are saved. Only
Away from home
the time must be re-adjusted if the power failure lasts more than 2 hours. The
thermostat will return to the mode that was active prior to the power failure.
Aube warrants this product, excluding battery, to be free from defects in the workmanship or materials,
under normal use and service, for a period of three (3) years from the date of purchase by the
consumer. If at any time during the warranty period the product is determined to be defective or
malfunctions, Aube shall repair or replace it (at Aube's option).
The Comfort ( ) temperature is used in periods 1 and 3 and the Economy
) temperature is used in periods 2 and 4. For example, when the period
changes from 1 to 2, the setpoint automatically changes from Comfort setting
) to Economy setting ( ).
If the product is defective,
return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased
ii) contact Aube. Aube will make the determination whether the product should be returned, or
whether a replacement product can be sent to you.
You can have a different program for each day of the week; i.e., each period
can start at different time for each day of the week. The thermostat has been
programmed with the following schedule.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown
by Aube that the defect or malfunction was caused by damage which occurred while the product was in
the possession of a consumer.
Aube's sole responsibility shall be to repair or replace the product within the terms stated above. AUBE
SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM
ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS
PRODUCT. Some provinces and states do not allow the exclusion or limitation of incidental or
consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY AUBE MAKES ON THIS PRODUCT. THE
DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE
THREE-YEAR DURATION OF THIS WARRANTY. Some provinces and states do not allow limitations
on how long an implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from province or
state to another.
0:00 10:00 10:00 10:00 10:00 10:00 10:00
PM PM PM PM PM PM PM
If you have any questions about the product installation or operation, or concerning the
warranty, contact us at:
To modify the schedule:
Press Pgm to access the programming mode. Period 1 is selected.
Press Day to select the day to program (hold for 3 seconds to select the
Tel.: (450) 358-4600
Fax: (450) 358-4650
Press Hour and Min to set the start time of the selected period, or press
Clear if you want to skip the period (--:-- is displayed).
Press Pgm to select another period, or press Day to select another day.
For more information on our products, go to
Then repeat step 3.
Press Mode to exit the programming mode.
NOTE: If no button is pressed for 60 seconds, the thermostat will automati-
cally exit the programming mode.
As an ENERGY STAR partner, Aube Technologies has
determined that this product meets the ENERGY STAR
guidelines for energy efficiency.