Selecting the Temperature Format
To select the temperature display format:
n Press the Up and Down buttons for three seconds.
The format currently used will be indicated on the
This is normal. Under normal operation, the ther-
mostat housing can reach a temperature
between 35 °C (95 °F) and 40 °C (104 °F).
Thermostat is hot.
o Press the Up or Down button to change the
Remediate if any the following conditions
p Press the Up and Down buttons for one second (or
The thermostat is exposed to air draft.
The sticker on the thermostat’s screen has
not been removed.
rature is wrong.
wait for one minute) to return to the normal display
The thermostat is located near or above a
heat source such as a light dimmer.
Temperature Display and Setting
The thermostat normally displays the actual (ambient) temperature.
The thermal protection device on the heater has
Display disappears temporarily opened. This can happen if the
and reappears after heater is obstructed by furniture or curtain and
To view the setpoint temperature, press once on
either temperature adjustment button. The setpoint
a few minutes.
has overheated, or if the heater’s thermal protec-
tion device is too sensitive.
will be displayed for 5 seconds. The icon
appears during the setpoint display.
To change the setpoint temperature, press the
appropriate button until the desired value is displayed.
Aube warrants this product, excluding battery, to be free from defects in the
workmanship or materials, under normal use and service, for a period of three
(3) year from the date of purchase by the consumer. If at any time during the
warranty period the product is determined to be defective or malfunctions,
Aube shall repair or replace it (at Aube's option).
If the product is defective,
During a power outage, the setpoint is saved in memory. You do not
need to adjust the temperature when power returns.
return it, with a bill of sale or other dated proof of purchase, to the place
from which you purchased it, or
Supply: 120/240 VAC, 50/60 Hz
contact Aube. Aube will make the determination whether the product
should be returned, or whether a replacement product can be sent to
Minimum load: 0.83 A (resistive only)
This warranty does not cover removal or reinstallation costs. This warranty
shall not apply if it is shown by Aube that the defect or malfunction was
caused by damage which occurred while the product was in the possession of
Aube's sole responsibility shall be to repair or replace the product within the
terms stated above. AUBE SHALL NOT BE LIABLE FOR ANY LOSS OR
DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY
BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER
FAILURE OF THIS PRODUCT. Some provinces, states or regions do not
allow the exclusion or limitation of incidental or consequential damages, so
this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY AUBE MAKES ON
THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES,
INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE THREE-
YEAR DURATION OF THIS WARRANTY. Some provinces, states or regions
do not allow limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.
00 W @ 240 VAC
00 W @ 120 VAC
Maximum load: 8.3 A (resistive only)
000 W @ 240 VAC
000 W @ 120 VAC
Display range: 0 °C to 50 °C (32 °F to 122 °F)
Setpoint range: 5 °C to 30 °C (40 °F to 85 °F)
Storage: -20 °C to 50 °C (-4 °F to 120 °F)
Heating cycle length: 15 seconds
This warranty gives you specific legal rights, and you may have other rights
which vary from one province, state or region to another.
Tel.: (450) 358-4600
Fax: (450) 358-4650
For more information on our products, go to