3
.
7.
Temperature Display and Setting
The thermostat normally displays the actual (ambi-
Warranty
;
Honeywell warrants this product, excluding battery, to be free from
defects in the workmanship or materials, under normal use and ser-
vice, for a period of one (1) year from the date of purchase by the
consumer. If at any time during the warranty period the product is
determined to be defective or malfunctions, Honeywell shall repair or
replace it (at Honeywell's option).
p
ent) temperature.
•
To view the setpoint temperature, press once on
either of the temperature adjustment buttons.
The icon
appears during the setpoint display.
•
To change the setpoint temperature, press the appropriate but-
ton until the desired value is displayed.
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to
the place from which you purchased it, or
4
.
(
ii) call Honeywell Customer Care at 1-800-468-1502. Customer
Care will make the determination whether the product should be
returned to the following address: Honeywell Return Goods,
Dock 4 MN10-3860, 1885 Douglas Dr N, Golden Valley, MN
Power Outage
During a power outage, the setpoint is stored in memory.
q
5
.
5
5422, or whether a replacement product can be sent to you.
Specifications
Supply: 120/240 VAC, 50/60 Hz
r
This warranty does not cover removal or reinstallation costs. This
warranty shall not apply if it is shown by Honeywell that the defect or
malfunction was caused by damage which occurred while the prod-
uct was in the possession of a consumer.
-
-
Minimum load: 2 A (resistive only)
5
2
00 W @ 240 VAC
50 W @ 120 VAC
Honeywell's sole responsibility shall be to repair or replace the prod-
uct within the terms stated above. HONEYWELL SHALL NOT BE
LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING,
DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WAR-
RANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF
THIS PRODUCT. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so this limitation may not
apply to you.
-
Maximum load: 12.5 A (resistive only)
3
1
000 W @ 240 VAC
500 W @ 120 VAC
-
-
-
-
Display range: 0 to 50°C (32 to 122°F)
Setpoint range: 5 to 30°C (40 to 85°F)
Storage: -20 to 50°C (-4 to 120°F)
Approval: c UL us
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEY-
WELL MAKES ON THIS PRODUCT. THE DURATION OF ANY
IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR-
POSE, IS HEREBY LIMITED TO THE ONE-YEAR DURATION OF
THIS WARRANTY. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply to
you.
6
.
s Troubleshooting
PROBLEM
SOLUTIONS
This is normal. Under normal operation, the
thermostat housing can reach a temperature
between 35°C (95°F) and 40°C (104°F).
Thermostat is hot
This warranty gives you specific legal rights, and you may have other
rights which vary from state to state.
Heater is always
On.
If you have any questions concerning this warranty, please write Hon-
eywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN
The thermostat has not been correctly wired.
5
5422 or call 1-800-468-1502. In Canada, write Retail Products
Thermostat indi-
cates that heating is
On, but the heater
is not On.
ON15-02H, Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive,
Scarborough, Ontario M1V4Z9.
The thermostat has not been correctly wired.
The thermostat is exposed to air draft. Elimi-
8
.
Customer assistance
ꢀ
Displayed tempera- nate the draft.
ture is wrong
If you have any questions about the operation of your thermostat,
Customer Care toll-free at 1-800-468-1502.
The sticker on the thermostat’s screen has
not been removed.
The thermal protection device on the heater
is open. This can happen after a power fail-
ure or or if the heater is obstructed by furni-
ture or curtains.
Display disappears
and reappears after
a few minutes
Display looks faded The heating system is less than the required
when heating is
activated
minimum load. This thermostat cannot be
used below that rating.
RLV310
69-1854
6/27/05
2/2